Step 5: Open the browser again and type 192.168.1.1 which is likely the the default internet IP address of your SLAVE router. Put one end of the cable in any of the LAN (Ethernet) ports available on the router and the other end in your computer’s Ethernet port. Now connect the SLAVE router to your computer using the physical Ethernet cable.
First reset the router to factory defaults by hard-pressing the reset button with a pin for about 10 seconds. Step 4: Next we need to configure SLAVE, our second router. B: Configure the Second Router as a Repeater
#I need the ip address for netgear router password#
If you have protected your Wi-Fi with a password, also note down the security mode used (WPA, WEP or WPA2) and your password (or secret passphrase). Step 3: Once you are inside the router settings, switch to Wireless Settings and make a note of the Wireless mode, the SSID and the channel. This will vary depending on your router’s manufacturer – just Google for default router password or try the standard combinations like admin/admin, admin/password and admin/blank>(no password). You’ll now have to provide the user name and password for accessing the router settings. If you are using IE, you might want to add to the address else IE may throw an error. Step 2: Open your web browser and type the router’s IP address into the address bar. If you are on a Mac, open the Terminal window, type the command route -n get default and make a note of the gateway value.įor this example, let’s assume that our MASTER router’s IP address is 192.168.30.1 and the Subnet Mask is set as 255.255.255.0. Open command prompt in Windows, type the command ipconfig /all and note the value of “Default Gateway.” That your main router’s IP address. Step 1: First we need to determine the IP address and the Subnet Mask of our MASTER router. Let’s call our main router MASTER (this is the router that is connected to the ISP modem) and the other one as SLAVE (the second router will work as a ‘repeater’ to increase your wireless range). The main router is in the ground floor while the second one is on the first floor and the entire premises get a good Wi-Fi signal. Then there’s a second wireless router (Wireless-G) that is connected to the main router over an Ethernet or Cat-5 cable. The main router is Wireless-N router connected to the ISP’s ADSL modem. Here’s how I have setup the wireless network at my home using 2 routers connected with an Ethernet cable.
The other inexpensive option is that you get hold of an old wireless router, one that is longer in use, and connect it to your existing (main) router using an Ethernet (Cat5) cable. You can easily extend your Wi-Fi network with additional networking hardware like Wi-Fi repeaters and Wireless Access Points.
#I need the ip address for netgear router full#
What should you therefore do to ensure that the Wi-Fi signals are available in full strength in every corner of your house including the lawn outside? There are quite a few options. The 802.11n routers, also known as Wireless N routers, offer a higher Wi-Fi range but even if you get one of these, the wireless signals may still not reach certain areas of your home because of all the physical obstructions. Expand your Wireless Network Range with a Spare Router You may have bought a new Wireless-N or Wireless-AC router but if there are any thick walls around, they will obstruct the Wi-Fi signal. The wireless range offered by your Internet router will vary depending on which Wi-Fi standard it supports (802.11n routers are better than Wireless-G routers) and also the router’s physical location.
0 kommentar(er)
